Crest Audio CDVS-4200 Series Provozní pokyny stáhnout pdf (Strana 46)

7-10

To Change a Single Camera:

Select the camera to make changes to by clicking with the mouse but-

ton, remote controller or front panel. e camera icon will turn yellow.

Check pop up box if you want the camera to pop up full screen on event

To rename the camera, click in the box. e

virtual keyboard will appear.

To change frame rate, click the up or down arrows.

To change the recorded image quality, click high mid

or low. High uses more disk space, but captures more

pixels.

Aer making the changes to the rst camera, you can duplicate the changes made, except for the camera

name, by clicking the right mouse button on the camera, it will turn yellow indicating it is selected. Aer se-

lecting the cameras you want to have the same settings, click the manual button. If you want all the cameras

to have the same settings click the all button aer making the changes to the rst camera.

Please note: e system will automatically lower the frame rate if you have selected a higher frame rate

than the system is capable of. e following chart shows the frame rate available for the dierent resolu-

tions.

CDVS-4204 CDVS-4208 CDVS-4216L CDVS-4216H

Low (CIF) 120 fps 120 fps 240 fps 480 fps

Mid (2 CIF) 60 fps 60fps 120 fps 240 fps

High (D1) 30 fps 30 fps 60 fps 120 fps

Please be aware that at least one fps is allocated for each port even if the port is not enabled. e actual

frame rate displayed on the screen may vary by one fps depending on how much motion is in the picture.

e more motion, the harder the processor has to work to encode the signal aecting performance.

Check the enable box to turn on the camera port.

Select camera resolution CIF, 2Cif or D1.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 80 81

Žádné komentáře

Crest Audio CDVS-4200 Series Provozní pokyny Strana 46